Latest Cisco 350-501 Exam questions and answers
Pass4SureQuiz 350-501 Exam Practice Test Questions (Updated 373 Questions)
NEW QUESTION # 112
An engineer must apply an 802.1ad-compliant configuration to a new switchport with these requirements; The switchport must tag all trame when it enters the port The switchport Is expected to provide the same level of service to traffic from any customer VLAN Which configuration must the engineer use?
- A. Option D
- B. Option B
- C. Option A
- D. Option C
Answer: A
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/cether/configuration/xe-3s/asr903/16-12-1/b-ce-xe-16-12-asr900/m_ce_802_1ad_900.html
NEW QUESTION # 113
Refer to the exhibit.
Which task completes the configuration?
- A. Specify the local-as value in the neighbor statement.
- B. Specify the activate neighbor 192.168.1.2 under the IPv4 address family.
- C. Specify the source interface in the neighbor statement.
- D. Specify the maximum number of prefixes that R1 receives from neighbor 192.168.1.2.
Answer: B
NEW QUESTION # 114
Refer to the exhibit. The USER mat is connecting an application on an Internet connection in AS 100 is facing these issues:
The USER lost the connection to the application during a failure Between IG and R2.
Router R2 configuration a lost due to a power outage.
The application the USER is connecting to a hosted behind CE2.
What action resolves the issues on R3 and R4 routers?
- A. Set R4 as a route reflector for R3 and CE2
- B. Apply low Local Preference on R4 toward R2.
- C. Apply high Local Preference on R3 toward R1
- D. Set R3 as a route reflector for R4 and CE1
Answer: B
NEW QUESTION # 115
Refer to the exhibit.
Refer to the exhibit. EIGRP is running between routers R5 and R1, and OSPF is used in the rest of the network. Users in a network attached to router R3 need to access a server connected to R5. Which task must the engineer perform so that only the users attached to R3 are able to access the server, but no other network is shared to OSPF?
- A. Configure an OSPF virtual link between R1 and R3 to route traffic between the two areas.
- B. Configure R1 as a stub router for EIGRP and OSPF so that only the default route is shared
- C. Configure redistribution using an offset list to filter the routes that are shared.
- D. Configure redistribution using route maps to filter the routes that are shared
Answer: D
NEW QUESTION # 116
When configuring traffic engineering tunnels in Cisco MPLS core network, you see the traffic is not taking the expected path in the core.
Which command do you use to quickly check path of a TE tunnel?
- A. ping <tunnel destination IP>
- B. show mpls traffic-engineering tunnels
- C. traceroute <tunnel destination IP>
- D. traceroute mpls ipv4 <tunnel destination>
Answer: B
NEW QUESTION # 117
A regional MPLS VPN provider operates in two regions and wants to provide MPLS L3VPN service for a customer with two sites in these separate locations. The VPN provider approaches another organization to provide backbone carrier services so that the provider will connect to these two locations.
What is the next step?
- A. When BGP is used for both route and label exchange, the neighbor a.b.c.d send-label command is used under the address-family VPNv4 command mode.
- B. When edge at different regional sites are connected over the global carrier backbone, MP-eBGP must run between routers to exchange the customer VPNv4 routes.
- C. When eBGP is used for label exchange using the send-label option. MPLS-BGP forwarding is configured under the global ABC CSC PE-to-CE interface.
- D. When IGP used for route exchange and LDP for label exchange, MPLS is enabled only on the VRF interface on the backbone-carrier PE side.
Answer: B
NEW QUESTION # 118
An engineer is implementing MPLS to monitor within the MPLS domain. Which must the engineer perform to prevent packets from being forwarded beyond the service provider domain when the LSP is down?
- A. Option D
- B. Option B
- C. Option A
- D. Option C
Answer: B
NEW QUESTION # 119 
Refer to the exhibit. Which statement supports QPPB implementation?
- A. QoS policies are identified in the MPLS forwarding table.
- B. QPPB policies affect only egress traffic.
- C. QoS policies use BGP to gain full coverage on the network.
- D. QoS policies rely exclusively on BGP attributes to manipulate traffic.
Answer: C
Explanation:
Section: Services
NEW QUESTION # 120
Refer to the exhibit.
Router 1 and router 2 are running BGP. and router 2 and router 3 are running OSPF Area 0. Router 1 is advertising loopback interlaces Lo 0 and lo 2. and router 2 is redistributing BGP into OSPF Area 0. Which configuration must an administrator apply so that router 2 uses a route map to redistribute only the internal route from Lo 2?
A)
B)
C)
D)
- A. Option C
- B. Option D
- C. Option B
- D. Option A
Answer: A
NEW QUESTION # 121
Refer to the exhibit. Which additional configuration must an engineer to the adge router to inject a default router into the MP-BGP address family for the internet_Shared_Services dedicated VRF?
A)
B)
C)
D)
- A. Option D
- B. Option B
- C. Option A
- D. Option C
Answer: A
NEW QUESTION # 122
Refer to the exhibit A network engineer is in the process of implementing IS-IS Area 1 and Area 2 on this network to segregate traffic between different segments of the network The hosts in the two new areas must maintain the ability to communicate with one another In both directions. Which additional change must be applied?
- A. Reconfigure routers R4, R5 and R6 as Level 1 routers
- B. Reconfigure routers R1, R2 R5. and R6 as Level 1/Level 2 routers.
- C. Reconfigure routers R2 and R5 as Level 1/Level 2 routers.
- D. Reconfigure either R3 or R4 as a Level 1/Level 2 router.
Answer: D
NEW QUESTION # 123
Refer to the exhibit:
Which statement about the neighbor statements for 192.168.1.1 is true?
- A. The router must have TDP configured for the send-label command to operate
- B. The neighbor router receives at least four labels from this router
- C. The router sends BGP labels for its prefixes to this peer
- D. The router sends only a label for the prefix for LoopbackO.
Answer: C
NEW QUESTION # 124
After a possible security breach, the network administrator of an ISP must verify the times that several different users logged into the network.
Which command must the administrator enter to display the login time of each user that activated a session?
- A. show platform software yang-management process
- B. show netconf-yang sessions detail
- C. show netconf-yang sessions
- D. show netconf-yang datastores
Answer: B
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-
xml/ios/prog/configuration/167/b_167_programmability_cg/configuring_yang_datamodel.html
NEW QUESTION # 125
Refer to the exhibit.
An engineer is implementing Auto-RP and reviewing the configuration of the PE-A. Which configuration permits Auto-RP messages to be forwarded over this interface?
- A. PE-A(config-if)#ip pim sparse-dense-mode
- B. PE-A(config-if)#ip igmp version 3
- C. PE-A(config-if)#ip pim sparse-mode
- D. PE-A(config-if)#no ip pim bsr-border
Answer: A
NEW QUESTION # 126
Refer to the exhibit an engineer working for a private telecommunication company with an employee Id: 4065:96:080 upgrades the WAN link between routers ASBR-101 and ASBR-201 to 1Gb by Installing a new physical connection between the Gi3 Interfaces. Which BGP attribute must the engineer configure on ASBR-201 so that the existing WAN link on Gi2 Is maintained as a backup?
- A. Option C
- B. Option D
- C. Option B
- D. Option A
Answer: A
NEW QUESTION # 127
After you analyze your network environment, you decide to implement a full separation model for Internet access and MPLS L3VPN services For which reason do you make this decision?
- A. It is easier to manage a system in which services are mixed
- B. It requires only one edge router
- C. It enables you to choose whether to separate or centralize each individual service.
- D. It enables EGP and IGP to operate independently
Answer: C
NEW QUESTION # 128
......
Pass Your Cisco Exam with 350-501 Exam Dumps: https://actualanswers.pass4surequiz.com/350-501-exam-quiz.html